Total Internal Reflection

Previous Topic

Return to Optical Fibers, Waveguides, and Lasers Menu

Next Topic

Total Internal Reflection

When θ₁ > θ_1c light can not enter medium n₂

A critical concept in the case of optical fibers is the case total internal reflection. The bending of light as it goes into medium is related to the index of reflection of the materials (n₁ and n₂). By Snell's law when n₁ > n₂ then θ ₁ is less than θ₂. As you decrease the angle θ₁ and bring the light closer to parallel with the interface you reach a critical angle θ_1c where there is total internal reflection.

Snells laws are also known as Fresnel's Equations:

<math>\theta _i = \theta _r\,\!</math>

and

<math>\frac {sin \theta_i} {\theta_t} = \frac {n_2} {n_1}\,\!</math>

where

<math>\theta_i\,\!</math> is the angle of incidence

<math>\theta_r\,\!</math> is the angle of reflection

<math>\theta_{c} = sin^{-1}(\frac {n_2} {n_1} )\,\!</math>

where:

<math>\theta_{c}\,\!</math> is the critical angle

<math>n_1 , n_2\,\!</math> are the index of refraction of the two media

if θ₁ keeps Increasing: θ₂ approaches 90°

for a critical angle Θ₁, Θ₂ = 90°and the beam emerges along the surface

When θ₂ = 90° → sin θ₂ = 1

If θ_i > θ_c then there is total reflection and there is no transmitted light in the second medium (the irradiance of the reflected and incident beams is equal). Light interacts at the interface and there is a phase shift between the incident and the reflected beams which is dependent on the two materials.

tan psi

This is a critical process in optical fibers and waveguides because it can carry light for long distances. For these values of index of refraction you get a critical angle of 78.6 which means the light must be very nearly parallel to the interface.

for n₁ = 1.53 and n₂ = 1.50 : θ_1c = 78.6°

As light passes from a vacuum into a medium with an index of refraction of 2, the wavelength get cut in half, and therefore it will take twice as long for to get through the medium. Again the frequency does not change.

Simulations

This flash simulation shows how total internal reflection and minimum radius of turns depends on the diameter of the optical fiber. The diameter changes how much of the light is below the critical angle where it is fully reflected.

<swf width="500" height="400">http://concave.stc.arizona.edu/thepoint/Interactive/ofiber.swf</swf>

This simulation allows you to select combinations of materials with different indexes of refraction. Try to get the best combination to achieve total internal reflection. <swf width="500" height="400">http://concave.stc.arizona.edu/thepoint/Interactive/ofiberapp2.swf</swf>

Previous Topic

Return to Optical Fibers, Waveguides, and Lasers Menu

Next Topic