Electronic States vs Molecular Levels

Previous Topic

Return to Band Structure Menu

The literature can be confusing in using the terminology of electronic states vs electrical levels.

Point Groups and symmetry

Hexatriene C_2h point group

There is always an identity symmetry (E). The hexatriene molecule is symmetrical around the C₂ axis. The C₂ axis is perpendicular from the plane of the molecule. A rotation of 180 degrees brings the same structure. The σ _h denotes symmetry above and below the plane, there must be the same electronic density above the plane as below. There is also an inversion symmetry (i) where the C₂ axis meets the plane. These together have a point group called C_2h.

Molecular level is a one electron wavefunction which is by definition a molecular orbital. Molecular levels corresponds to molecular orbitals (HOMO, LUMO etc).

Molecular states (which is what you can observe) is a wavefunction that results from all the electrons in the molecule.

Electronic configuration and molecular orbitals for hexatriene

The electronic configuration is shown with six molecular orbitals, three of which on the π level are fully occupied. Another configuration in which individual electrons move up to the π* level are called singly excited. If two electrons are elevated from occupied levels into unoccupied levels these are called doubly excited configurations. The way electrons fill into the orbitals corresponds to electronic configurations.

The wavefunctions can be classified according their symmetry. The lowest level is the fully bonding an is unsymmetrical; it is labeled ungerade (u- german for odd). The next level up has a node in the middle and it is symmetrical and is labeled gerade (g - german for even). In π conjugated systems molecular orbitals alternative between gerade and ungerade with each level.

The Ground State

An electronic state is described by a weighted combination of electronic configurations. In many instances however the ground state and the lowest excited states can be described by only one or very dominant configurations.

In polyenes the ground state with all π and σ levels doubly occupied is denoted A_g symmetry, or 1A_g. This is also called state S₀.

The lowest ground stat π-type excited states can be of A_g or B_u symmetry.

1B_u Excited state

The 1 B_uexcited state

The 1 B_u excited state is dominated by a (singly excited) configuration with promotion of one electron from HOMO to LUMO. Suppose you shine a light on a molecule and cause an electron to enter the excited state. In order for the transition to be allowed you need to have different symmetries for the ground state and for the excited state. If the ground state is gerade (even) the excited state must be ungerade (odd). This is because transition dipole operator is an odd function.

This can be noted using Dirac notation.

<math>\langle g \vert \overrightarrow{r} \vert u \rangle\,\!</math>

The integral over all space of initial state gerade (g) the the dipole operator (r) and the wave function for the final state (u). In order for the integral to non zero the product for all three terms must be even for a level. Therefore the transition to the 1B_u excited state is possible.

<math>B_u symmetry \rightarrow 1B_u state\,\!</math>

If there were a transition to a gerade excited state the product (g, r and g) would be odd and therefore the integral would be zero. The probability for an electron to go from the 1A_g to the 2A_g state is taken as the square of the transition dipole function, so if the function is zero, its square is zero and therefore the probability of the transition is zero. If an molecule has no symmetry it go from the ground state to any excited state. As soon as a molecule has symmetry there are selection rules that apply. Experimentally it is impossible to excite a polyene molecule to the 2A_g state. The transition dipole is zero, this is known as a forbidden transition. The fact that a transition dipole is non-zero does not tell about the probability in itself; it could be exceedingly small probability. However a non-zero transition dipole has at least some probability and therefore is not forbidden transition.

2A_g excited state

Three possible electronic states for the 2A_g excited state

For a long time the one-photon allowed 1B_u was thought to be the lowest possible excited state for a polyene molecule also called S₁ (the lowest singlet excted state). But the papers by Hudson and Kolher showed that the lowest excited state in a long polyene is actually the 2A_g (the second state of A_g symmetry). There is not a single electronic state that dominates that wave function. One involves the promotion from HOMO to the LUMO plus 1 which is gerade. A second case promotes an electron from the HOMO-1 to the LUMO, which is also gerade. There is also a doubly excited situation in which two electrons are promoted from the HOMO to the LUMO resulting in a gerade state.

As long as they have the same symmetries they can mix. These three configurations have approximately the same energies so they can mix strongly. They are one photon forbidden (but two photon allowed). This results in a 2A_g state that is energetically lower than the 1B_u state, thus it should be considered the S₁ state.

<math>\begin {multline}

E 2 A_g < E 1B_u \\ S_1 \quad S_2 \end{multline} \,\!</math>

Transition from 1B_u to 2A_g results in a metastable state.

There can not be an optical transition from the 1A_g to the 2A_g state but there will be absorption indicating a transition to the 1B_u state which is higher in energy. From there it can vibrate and lower its energy through the process of internal conversion to the 2A_g state where it stays because the transition to the 1A_g state is forbidden. This results in a metastable state which is observed as quenching of the luminescence.

Previous Topic

Return to Band Structure Menu