Difference between revisions of "Organic Photovoltaic Fabrication and Test Apparatus"
Cmditradmin (talk | contribs) (New page: <swf width="600" height="500">http://depts.washington.edu/cmditr/media/opvfab.swf</swf>) |
Cmditradmin (talk | contribs) |
||
| Line 1: | Line 1: | ||
<swf width="600" height="500">http://depts.washington.edu/cmditr/media/opvfab.swf</swf> | <swf width="600" height="500">http://depts.washington.edu/cmditr/media/opvfab.swf</swf> | ||
It takes many trials to perfect the materials and techniques that make for highly efficient organic solar cells. This apparatus at University of Arizona combines a vacuum fabrication area with a inert gas glove box where prototype cells can be tested under controlled circumstance. | |||
The most common test is to generate a voltage vs current curve by experimentally varying the level of light used to excite the cell and by continually changing the load on the cell using a variable voltage power supply (reverse polarity). First a the cell is kept in the dark and a whole series of voltages are applied while the current is measured. Then this series of measurements is repeated while the cell is illuminated. Typical measurements open-circuit voltage (V<sub>oc</sub>), short-circuit current (I<sub>sc</sub>), fill factor (FF), maximum power output of the device (P<sub>max</sub>), voltage at maximum power (V<sub>max</sub>), current at maximum power (I<sub>max</sub>). | |||
See wiki article on [[Physics_of_Solar_Cells]] | |||
Revision as of 14:22, 1 June 2009
<swf width="600" height="500">http://depts.washington.edu/cmditr/media/opvfab.swf</swf> It takes many trials to perfect the materials and techniques that make for highly efficient organic solar cells. This apparatus at University of Arizona combines a vacuum fabrication area with a inert gas glove box where prototype cells can be tested under controlled circumstance.
The most common test is to generate a voltage vs current curve by experimentally varying the level of light used to excite the cell and by continually changing the load on the cell using a variable voltage power supply (reverse polarity). First a the cell is kept in the dark and a whole series of voltages are applied while the current is measured. Then this series of measurements is repeated while the cell is illuminated. Typical measurements open-circuit voltage (Voc), short-circuit current (Isc), fill factor (FF), maximum power output of the device (Pmax), voltage at maximum power (Vmax), current at maximum power (Imax).
See wiki article on Physics_of_Solar_Cells